1. Can anyone explain how exactly Flame thrower work?
2. Do all faction FT has the same stats?
3. Do Ost Halftrack FT & KV8 has different stats to infantry's FT?
Flame thrower
25 Jun 2021, 10:57 AM
#1
Posts: 176
25 Jun 2021, 11:03 AM
#2
Posts: 3114 | Subs: 2
Afaik: Flame throwers target a model (or a spot when attacking ground) and apply an AoE around this model. They deal 16 damage to all models within the AoE. That's at least how I understand pio flame throwers, and I think the infantry based ones are all the same.
I think the 251 has either damage over time component to it or there are multiple damage checks during one visual burst of flames, but not sure. Maybe it sets the ground on fire which causes the DoT (that's how molotovs deal most of their damage).
EDIT: Just to be clear: The 251 does some damage upfront followed by additional DoT damage as described above.
I think the 251 has either damage over time component to it or there are multiple damage checks during one visual burst of flames, but not sure. Maybe it sets the ground on fire which causes the DoT (that's how molotovs deal most of their damage).
EDIT: Just to be clear: The 251 does some damage upfront followed by additional DoT damage as described above.
25 Jun 2021, 11:46 AM
#3
Posts: 13496 | Subs: 1
...
As far as I know:
Hand held flamer do only attack/splatter damage
Vehicle flamer do attack/splatter damage and set the ground on fire for DOT.
Flamer also have different modifier and do more damage/less to certain type of cover/terrain.
(Extra damage to garrison/less damage to water/negative)
Hand held flamer do similar damage, vehicles not so much.
25 Jun 2021, 12:30 PM
#4
Posts: 3114 | Subs: 2
(Extra damage to garrison/less damage to water/negative)
Hand held flamer do similar damage, vehicles not so much.
That's a good point too. They deal more damage vs units in green cover in general. Yellow cover is not affected iirc.
Basically if you see a flamer and your units are behind a sand bad: Run to the open field. First you do not get the additional damage modifier, second your models space out, causing less models to get hit per burst.
25 Jun 2021, 15:53 PM
#5
Posts: 3166 | Subs: 6
Afaik: Flame throwers target a model (or a spot when attacking ground) and apply an AoE around this model. They deal 16 damage to all models within the AoE. That's at least how I understand pio flame throwers, and I think the infantry based ones are all the same
16 damage to targets in the open or light cover. 20 damage against heavy cover or garrison. So 5 or 4 bursts to kill a model (80hp) depending on the type of cover.
They also have 2.5 penetration compared to standard small arms' 1, so they're good against armored infantry (Shocks and heavy Sappers) and they can damage light vehicles to some extend.
I think in vCoH they used to deal less damage to targets that were in water, but I'm not sure if they copied that over to CoH2.
25 Jun 2021, 17:49 PM
#6
Posts: 1594
16 damage to targets in the open or light cover. 20 damage against heavy cover or garrison. So 5 or 4 bursts to kill a model (80hp) depending on the type of cover.
They also have 2.5 penetration compared to standard small arms' 1, so they're good against armored infantry (Shocks and heavy Sappers) and they can damage light vehicles to some extend.
I think in vCoH they used to deal less damage to targets that were in water, but I'm not sure if they copied that over to CoH2.
They only do four more damage to models in Green cover? Strange, it always felt like they did more that that. Perhaps its just a factor of them generally also being very bunched up (And in the case of Garrisons, it hits all models automatically, right?)
I feel as though I've noticed Flamethrower bursts occasionally doing no damage, too, but I dont have any evidence of this, and can't really think why it would be the case.
25 Jun 2021, 18:01 PM
#7
Posts: 2458 | Subs: 1
They only do four more damage to models in Green cover? Strange, it always felt like they did more that that. Perhaps its just a factor of them generally also being very bunched up (And in the case of Garrisons, it hits all models automatically, right?)
I feel as though I've noticed Flamethrower bursts occasionally doing no damage, too, but I dont have any evidence of this, and can't really think why it would be the case.
That might be because your unit is sitting in a trench and the flamethrower can't aim downwards. It happens for trenches like the ones used for Rails and Metals and Alliance of Defiance.
25 Jun 2021, 19:51 PM
#8
Posts: 3114 | Subs: 2
That might be because your unit is sitting in a trench and the flamethrower can't aim downwards. It happens for trenches like the ones used for Rails and Metals and Alliance of Defiance.
They only do four more damage to models in Green cover? Strange, it always felt like they did more that that. Perhaps its just a factor of them generally also being very bunched up (And in the case of Garrisons, it hits all models automatically, right?)
I feel as though I've noticed Flamethrower bursts occasionally doing no damage, too, but I dont have any evidence of this, and can't really think why it would be the case.
Flame throwers can apparently be blocked by terrain objects. So in some instances the flames can't fire through terrain or rocks, despite the model trying to attack through the terrain. I think this can be the case for trenches (as in trenches on the map, not the buildable British ones): The flame hits the ground in front of the trench, so the flame is blocked.
26 Jun 2021, 02:11 AM
#9
Posts: 999 | Subs: 1
Flame throwers can apparently be blocked by terrain objects. So in some instances the flames can't fire through terrain or rocks, despite the model trying to attack through the terrain. I think this can be the case for trenches (as in trenches on the map, not the buildable British ones): The flame hits the ground in front of the trench, so the flame is blocked.
to add to this; usually moving a tad bit closer to the target fixes the dealing no damage issue for some obscure reason. not sure if this is the same for elevation differences such as trenches or cliffs, though.
||| ScatterThis! - Tank AI calculation made easy ||| CoH2 Pen Calc - Tank vs tank... who wins against who and by what margin? |||
26 Jun 2021, 08:59 AM
#10
Posts: 4183 | Subs: 4
I think in vCoH they used to deal less damage to targets that were in water, but I'm not sure if they copied that over to CoH2.
IIRC they do do half damage to units in water, not that'd really be an issue though unless you find yourself in the unlikely situation of fighting dual flamers with no other small arms.
That might be because your unit is sitting in a trench and the flamethrower can't aim downwards. It happens for trenches like the ones used for Rails and Metals and Alliance of Defiance.
I experienced this the other day on rails when a player was spamming royal flamers at me when I was in the fuel trench. This should be looked at and fixed if possible. It's pretty shocking to see 4 flamers do absolutely nothing to a squad in a trench.
0 user is browsing this thread:
Livestreams
 |
|
|
24 | ||
 |
|
|
13 | ||
|
|
|
|
9 | ||
|
|
|
|
4 | ||
 |
|
|
260 | ||
|
|
|
|
56 | ||
 |
|
|
30 | ||
|
|
|
|
2 | ||
|
|
|
|
1 | ||
|
|
|
|
1 |
Ladders Top 10
-
#Steam AliasWL%Streak
- 1.831222.789+37
- 2.34957.860+14
- 3.589215.733+4
- 4.1099614.642-1
- 5.280162.633+8
- 6.305114.728+1
- 7.916405.693-2
- 8.271108.715+22
- 9.721440.621+3
- 10.1041674.607-2
Data provided by
Relic Entertainment
Relic Entertainment
Replay highlight
VS
-
cblanco ★ -
보드카 중대
-
VonManteuffel -
Heartless Jäger
Einhoven Country
Honor it
9
Download
1231
Board Info
672 users are online:
672 guests
1 post in the last 24h
7 posts in the last week
39 posts in the last month
7 posts in the last week
39 posts in the last month
Registered members: 49065
Welcome our newest member, Huhmpal01
Most online: 2043 users on 29 Oct 2023, 01:04 AM
Welcome our newest member, Huhmpal01
Most online: 2043 users on 29 Oct 2023, 01:04 AM